OMC Service Bulletin No. 2094: Erratic Engine Operation in Cold Water

December 1983 OMC powerhead bulletin for 4RDCRM and 5RCNR through 5RCRM models addressing poor low-speed operation in cold water.

OMC Outboard Service Bulletin
Powerhead
No. 2094
December, 1983
Subject:Erratic Engine Operation in Cold Water
Models:4RDCRM, 5RCNR thru 5RCRM

Problem - The powerhead does not maintain minimum operating temperature.

Symptom - Poor idle and erratic low speed operation

Parts Required - Metering Rod P/N 328157 and Exhaust Cover Gasket P/N 323445.

1Solution - The motor should be checked where operating conditions can be duplicated. Run the motor for at least five minutes at a maximum speed of 3000 rpm. Mark the cylinder water jacket with a 38° C (100° F) temperature melt stick. The mark will appear dull and chalky. When the surface temperature reaches the temperature rating of the stick, the mark will melt becoming liquid and glossy in appearance. On some painted surfaces on which the stick will not leave a mark, it will be necessary to hold the stick against the surface.

2If the stick does not melt at 1000 rpm or less the motor should be modified. Remove the exhaust cover and install a metering rod P/N 328157 A in the water passage hole B between the exhaust water passage and the cylinder water passage.

Apply OMC Gasket Sealing Compound P/N 317201 to both sides of the exhaust cover gasket. Install all screws finger tight. Then tighten screws to a torque of 2,8 - 4,0 N·m (25 - 35 in. lbs.).

Figure 1: marking cylinder water jacket with temperature melt stickFigure 2: metering rod installation points A and B

Related marine products

eBay: OMC / Evinrude part 328157

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.

Related products

Metering rod P/N 328157 and exhaust cover gasket P/N 323445 - recommendations coming soon.