
Subject: Carburetor Cleaning Procedures
Models: All Outboard, OMC Sea Drive® and OMC Sail Drive™
The carburetors used on Outboard, OMC Sea Drive and OMC Sail Drive Models must be completely disassembled before cleaning. Refer to the current parts catalog to familiarize yourself with the parts that can be removed before disassembly. Use the service manual for disassembly and assembly information.
Observe the following procedures when cleaning carburetors:
- Never clean carburetors by submerging in a hot tank or carburetor cleaner.
- Do not clean float, inlet valve, plastic or electrical parts with carburetor cleaner.
- ⚠ To prevent eye injury, wear safety glasses.
- Place parts to be cleaned in a shallow tray.
- ⚠ Use an aerosol carburetor cleaner to spray carburetor parts. Observe instructions on can for use of cleaner.
- Use a small bristle brush to scrub any gum or varnish.
- Use the nozzle of the aerosol cleaner and spray through metering passages.
- Use shop air of not more than 25 psi (172kPa) to blow parts clean and allow to air dry.
- Do not use rags to clean carburetors.
- Use care not to damage gasket surfaces.
- Inspect new gaskets to ensure all holes are correctly punched and for loose fibers or particles of gasket material.
NoteDo not apply OMC Engine Cleaner directly on rubber or similar parts. Castings and metering tubes are sealed with sealing compounds. To avoid disturbing sealing compounds do not soak carburetors in carburetor cleaner or use excess pressure to blow parts clean.

