Subject: Tachometer Requirements Models: CR and Commercial V-4 & V-6 Trim/Tilt Models
Problem - Tachometers using the alternator pulse for RPM sensing may be inaccurate and unstable if the instrument is not designed for use with CR models listed. All tachometer manufacturers were notified in June of 1982, of the CR model tachometer requirements.
Cause - CR V-4 trim/tilt and V-6 models use a rectifier/regulator assembly which provides a tach signal that is significantly different than that provided on an engine which does not have the rectifier/regulator. This system improves voltage control of battery charging to use the increasingly popular ‘‘maintenance free’’ batteries.
The following information will help you identify the two types of rectifier/regulators used:
The air cooled rectifier/regulator assembly @ is only used on V-6 models. It is mounted on the port side of the engine. (10 amp stator shown)
The water cooled rectifier/regulator assembly is used on V-4 and V-6 models. It is mounted at the rear of the engine and replaces the water cover. (35 amp stator shown)
Solution:
OMC* Tachometer - Refer to the current OMC Accessories catalog for the correct OMC SysteMatched™ tachometer for the motor.
Non OMC Tachometer — Check the tachometer part number with the manufacturer’s application chart or contact the manufacturer. Most tachometer manufacturers maintain a sales application staff that can assist dealers with technical problems.
wy


