This November, 1984 bulletin addresses propeller hub and bushing assemblies for SST and aluminum propellers for 20 thru 35 motors with thru-hub exhaust gearcases.

Subject: Propeller Hub and Bushing Assemblies, P/N 392881 & P/N 386638
Models: SST and Aluminum Propellers for 20 thru 35 Motors With Thru-Hub Exhaust Gearcases
Problem: The propeller hub splits when installing the hub and bushing assembly into a propeller.
Cause: Using incorrect hub and bushing assembly.
Solution:
1. Check hub for two moulded ribs (A), which indicates the current hub and bushing assembly.
Note: Do not use a hub and bushing assembly without the moulded ribs, the propeller may slip under power, causing engine damage.
There are two different type hub and bushing assemblies, both assemblies must have the moulded ribs.
2. For SST propellers, use hub and bushing assembly (B) P/N 392881. This hub and bushing assembly is identified by yellow paint (C) on the bushing.
For the aluminum propeller, use hub and bushing assembly (D) P/N 386638.


When installing a hub and bushing assembly use the correct lubricant. We recommend P-80 Rubber Lubricant (or equivalent).
P-80 Rubber Lubricant is available from:
International Product Corp., P.O. Box 118, Trenton, New Jersey 08601; or Meyer Engineering Co., 2635 Sheridan Road, Zion, Illinois 60099, Telephone: (708) 746-1500.
Follow mixing directions supplied by the manufacturer.
Suggested products related to this service bulletin. Verify fit and suitability before ordering.
Search for original or compatible replacement part 392881
Click here to search on eBayAffiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.