December 1984 OMC gearcase bulletin concerning redesigned propeller shaft bearing housing screws and seals.

OMC Outboard Service Bulletin
Gearcase
No. 2137
December, 1984
Subject:Redesigned Propeller Shaft Bearing Housing Screws, P/N 316563 and P/N 320041

1. Propeller shaft bearing housing screw Ⓐ, P/N 316563, and O-ring Ⓔ, P/N 317178, are being replaced by a new screw and seal Ⓑ.

2. Propeller shaft bearing housing screw Ⓒ, P/N 320041, and O-ring Ⓔ, P/N 317178, are being replaced by a new screw and seal Ⓓ.

The new screws retain the original part numbers and are being introduced for service and as running production changes. The new screws are available as assemblies only.

Note DO NOT use O-ring Ⓔ, P/N 317178, on the new screws. The O-ring will not seal properly when used on the new screws resulting in loss of gearcase lubricant.

The O-ring Ⓔ is available to service the original screws, however, we recommend installing the new screw assemblies. The new screw and seal designs allow removal and installation without damaging the seal.

Apply OMC Gasket Sealing Compound to the new screw threads and seal before installation.

Factory illustration 1Factory illustration 2
CR 84-120

Related marine products

eBay: OMC / Evinrude part 316563

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.