Stator and crankcase bearing-head fastener service instructions for CR V-6 outboards and OMC Sea Drive models with 35 amp alternators.





Subject: 35 Amp Stator Retaining Screws and Upper Crankcase Bearing Head Screws Models: CR V-—6 Outboards and OMC Sea Drive® Models with 35 Amp Alternators Problem: Engine vibration can loosen Stator Screws, P/N 512321, and Bearing Head Screws, P/N 306049. Symptom: Damaged stator and loss of electrical power. Solution: ] 2] 3] Remove flywheel and four stator screws (A) . Remove any varnish around retaining screw holes (8) on both sides of stator. Install new or original screws that have nylon locking patch ©). Tighten screws to a torque of 14—16 N-m (10—12 ft. Ibs.). Note Discard lock washers if used on original stator screws. a Remove four upper crankcase bearing head screws (0). Clean screw threads and mounting hole threads. Apply OMC Locquic™™ Primer, P/N 384884, to screws and holes and OMC Screw Lock, P/N 384848. Tighten screws to a torque of 8—11 N-m (6—8 ft. Ibs.). Note Crankshaft and flywheel tapers must be clean and free of oil before reinstalling flywheel. Tighten flywheel nut to 190—200 N-m (140-145 ft. Ibs.). Electrical No. 2138 December, 1984 [3] 1597 CR85-8
Listings matching the part number
Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.