OMC Service Bulletin No. 2144 - Clutch Dog Failure

Published February 1985. Clutch dog failures may result from improper shifting at excessive engine speed.

OMC Outboard Service Bulletin
Gearcase
No. 2144
February, 1985
Subject:
Clutch Dog Failure
Models:
All Evinrude® and Johnson® V6 Models
Problem:
There have been a number of clutch dog failures attributed to improper shifting. Excessive forces can be applied to the clutch dog when the gearcase is shifted above normal engine idle speeds.
Solution:
Inform the operator that failures of this type can be prevented by following this shifting procedure:

1. Be sure that the engine is at normal operating temperature before attempting to shift. This will assure that the engine will continue to run when the fast idle lever is brought to run position or the control handle is brought to the neutral position (depending on the type of remote control being used).

2. After warm-up, do not shift until engine RPM has slowed to normal idle speed.

Note The correct engine idle speed in forward gear for V6 models is 650 RPM.

3. Shift BRISKLY into forward or reverse gear.

4. When shifting between forward and reverse, always hesitate briefly in neutral before shifting briskly into gear. This reduces clutch dog (propeller shaft) RPM to allow easier shifting and positive clutch dog engagement.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.