OMC Service Bulletin No. 2145 - Installation of Trim/Tilt Gauge

Published February 1985. Trim/tilt gauge reads in the opposite direction when installed incorrectly.

OMC Outboard Service Bulletin
Accessories
No. 2145
February, 1985
Subject:
Installation of Trim/Tilt Gauge
Models:
All CO Models with Trim/Tilt
Problem:
Trim/tilt gauge gives opposite reading when installed per the instructions supplied with the gauge.
Cause:
Different assembly procedure of trim/tilt gauges from the factory.
Solution:
Remove and reinstall, rotating the gauge 180° as shown.
Figure 1: improper gauge installationFigure 2: proper gauge installation

1 Improper installation (gives opposite reading).

2 Proper installation (gauge rotated 180° to give correct reading).

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Marine Outboard Tachometer / Boat Dash Gauge

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.