OMC Service Bulletin No. 2148, issued April 1985, addresses accessory weedless propeller clearance to skeg modification for 1983-1985 24 Volt Electric Outboard.

OMC Outboard Service Bulletin
Electric Outboards

No. 2148
April, 1985

Subject: Accessory Weedless Propeller Clearance to Skeg Modification

Models: 1983-1985 24 Volt Electric Outboard

Problem: Blade makes contact with skeg when running at medium or high thrust setting.

Symptom: Operator would notice a “ticking” noise or vibration.

Solution:

1. Using a file, remove enough material from skeg A to provide 5mm (3/16 in.) minimum clearance.

2. This modification applies only when using propellers that are flush with hub at drive pin location.

3. Latest propellers have additional material at drive pin location B to provide ample clearance.

Note: Some propellers may develop a vibration not related to interference with skeg. If this occurs, remove propeller, turn 180° on drive pin and reinstall.

Factory illustration 1 for bulletin 2148Factory illustration 2 for bulletin 2148Factory illustration 3 for bulletin 2148

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Skeg Guard / Metal File

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.