
Problem 1: Motor overheats at midrange speeds:
Cause: Misalignment of parts in the water pump assembly.
Solution:
Check the following items to determine if the water pump was assembled correctly.
1 2 1. Alignment tab Ⓐ of the impeller cup not lining up with the slot Ⓑ in the impeller plate. Inspect the impeller plate for damage. Replace any plate that is bent or deformed.
3 2. Check for extremely deformed mounting holes on the impeller housing. Replace the impeller housing if necessary.



(Continued)
Problem 2: Motor overheats at high speeds:
Cause: Plugged vent hole or passage in the impeller cup or housing.
Solution:
4 5 1. Check for a plugged vent hole Ⓐ in the impeller cup or blocked vent passage Ⓑ in the impeller housing. To properly inspect the vent hole and passage, the cup must be removed from the impeller housing.
6 2. During inspection of vent hole passage, check for a missing or damaged seal ring Ⓒ between impeller cup and housing. Replace the seal if necessary.
Assembly of Pump:
When installing the water pump assembly, observe the following:




Suggested products related to this service bulletin. Verify fit and suitability before ordering.
Search for original or compatible replacement part 324701
Click here to search on eBayAffiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.