OMC Service Bulletin No. 2163 - No Power at Slow Speed Position

March 1986 bulletin for 1982 and later electric outboards with thermal cutout, addressing overheated resistors and loss of slower speeds.

OMC Outboard Service Bulletin
Electric Outboards
No. 2163
March, 1986
Subject:No Power at Slow Speed Position
Models:Electric Outboards, 1982 and Later with Thermal Cutout
Problem:Severe use can cause resistor to overheat.
Symptom:Loss of slower speeds
Solution:

1 Remove thermal cutout assembly, rotate terminal Ⓡ 180°, and solder resistor wire directly to terminal.

1 2 Apply a sufficient amount of OMC Heat Sink Compound P/N 322170 to the outside diameter of the resistor to fill the gap between resistor and adaptor. This will improve the transfer of heat to the adaptor for better cooling.

Figure 1 terminal RFigure 2 resistorFigure 3 heat sink compound application

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

eBay: OMC / Evinrude OEM part 322170

Search for original or compatible replacement part 322170

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.