October 1986 bulletin on gelled TC-W oil and VRO pickup filter P/N 174377 for CR, CO, and early CD outboards.

An additive used through 1985 in several brands of NMMA (B.I.A.) certified, TC-W lubricants, including OMC oils, has been found to cause the formation of some gel-like substance in the oil under certain conditions.
The additive formulation used in OMC oils has been corrected by the supplier. OMC oils containing the earlier additive, as well as a number of other brands using similar additives, may still be available from many sources.
The gelled oil completely dissolves when mixed with fuel. The gelled oil, however, can obstruct the very fine filter screen in the VRO oil pickup tube of CR, CO, and early CD model motors. If this occurs, powerhead failure can result.
The larger filter, P/N 174377, used in late CD model VRO oil tanks will pass the gelled oil, which then mixes with fuel in the VRO pump.
When servicing a CR, CO or early CD model VRO equipped outboard, we recommend replacement of the small filter with the large filter, P/N 174377. The new filter lists for $4.00 and should take no more than one-half hour to install. Replacement of the filter will not be covered under warranty.
Be sure to remove the small cone-shaped filter from inside the pickup tube with needle-nose pliers, and remove the foam baffle, if so equipped. Make certain no air leaks are created when servicing the VRO system. If the pickup/oil housing moves on the rods when the larger filter is pressed on, the position of the pickup must be readjusted. Refer to the service manual for correct pickup depth.
Suggested products related to this service bulletin. Verify fit and suitability before ordering.
NMMA TC-W3 2-Stroke Marine Outboard Oil
Search for these supplies on AmazonSearch for original or compatible replacement part 174377
Click here to search on eBayAffiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.