OMC Service Bulletin No. 2180: VRO Pump Fuel Outlet Fitting Breakage

October 1986 two-page bulletin on VRO pump fuel outlet hose breakage in CO V-8 Evinrude and Johnson outboards, including hose replacement and service tools.

OMC Outboard Service Bulletin
Subject:
VRO® Pump Fuel Outlet Fitting Breakage
Models:
CO V-8 VRO Equipped Evinrude® and Johnson® Outboards
Problem:
The VRO fuel outlet fitting breaks and allows fuel to leak out of pump.
Cause:
Nonformed fuel outlet hoses on VRO pumps may cause tension on outlet fittings and cause breakage.
Solution:
When servicing engines, the fuel outlet hoses on both VRO pumps must be replaced. The replacement hoses are preformed, which eliminates the tension on the VRO fuel outlet fitting.

NoteWhen removing or installing the VRO pump outlet hoses, use extreme caution. If too much force is applied, the fitting could be damaged.

Removal of VRO Hoses

1Remove the tie straps from the upper and lower VRO pump outlet hoses.

2Cut the hose near the outlet fitting on both pumps using a knife or diagonal cutters.

3Cut the remaining hose from the outlet fittings using a knife, being careful not to damage fitting.

Remove hose clamp from the manifold nipple using OMC Hose Clamp Wrench P/N 325043. Carefully pull the fuel hose off the manifold fitting.

4Remove the three tie straps from the three-way tee.

4Remove the three hoses from the tee, discard hoses.

(Continued)

Fuel System
No. 2180
October, 1986
Factory figures 1 through 4 showing VRO pump outlet hose removal and fittings
OMC Outboard Service Bulletin

Installation of new fuel hoses

NoteCheck tee fitting for cracked or damaged nipples. If damaged, replace fitting.

5Install OMC Manifold Hose P/N 323401 Ⓐ, OMC Lower Pump Outlet Hose P/N 331951 Ⓑ and OMC Upper Pump Outlet Hose P/N 324370 Ⓒ onto tee connector.

6Install three tie straps and tighten using OMC Tie Strap Installer P/N 323716.

5Slide manifold hose Ⓐ onto manifold fitting. Reinstall clamp onto hose and tighten clamp securely.

7Install the hose Ⓑ onto the lower VRO pump outlet fitting.

8Install the hose Ⓒ onto the upper VRO pump outlet fitting.

9Install tie straps securely to the lower and upper VRO pump outlet hoses.

⚠ Check fuel system for leaks.

Order the three hoses P/N 323401, P/N 324370 and P/N 331951 and five tie straps P/N 320107 from your OMC Parts Distributor. Submit a warranty claim for parts and 1.5 hours labor at your existing labor rate to:

Outboard Marine Corporation
Product Warranty Department
3145 Central Ave.
Waukegan, Il. 60085

Factory illustration 5Factory illustration 6Factory illustration 7Factory illustration 8Factory illustration 9

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

NMMA TC-W3 2-Stroke Marine Outboard Oil

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 325043

Search for original or compatible replacement part 325043

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.