August 1987 OMC gearcase bulletin addressing loose bearing housing screws on 155 WTL, WTX and V-8 outboards.

OMC Outboard Service Bulletin
Gearcase

No. 2192
August, 1987

Subject:Loose Propeller Shaft Bearing Housing Screws
Model:155 WTL, WTX and V-8 Outboards
Problem:

Water in gearcase, gear damage, or propeller hub contacting screws.

Solution:
I. Modify propeller shaft bearing housing retainers.

II. Install new bearing housing retainer screws and new flat washers.

III. Replace propeller thrust bushing if required.

Figure 1 bearing housing retainer modificationFigure 2 propeller thrust washers

When servicing these models, check the propeller shaft bearing housing screws. If screws are loose:

1 I. Remove and modify both retainers. Measure 9/32 in. (7,0 mm) at A and mark retainers. Measure 3/32 in. (2,4 mm) at B and mark retainers. Remove material from the four corners of the retainers as shown.

II. Install new flat washers, P/N 328743, onto new bearing housing retainer patchlock screws P/N 913432. Install modified retainers and secure with new flat washers and new screws. Tighten screws evenly to a torque of 18-20 ft. lbs. (24,5-27,0 N·m).

2 III. Inspect propeller thrust washer part number. If thrust washer is P/N 321173, replace it with a 1/16 in. (1,6 mm) thicker thrust washer P/N 333592.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Hub Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 328743

Search for original or compatible replacement part 328743

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.