OMC Service Bulletin No. 2198 - Powerhead Overheating

This bulletin addresses water inlet screen blockage on 20-35 HP recreational outboards and recommends additional water inlet holes for commercial and high-usage applications.

OMC Outboard Service Bulletin
Gearcase

No. 2198
December, 1987

Subject:
Powerhead Overheating
Models:
All 20-35 Recreational Models, CS and Later
Problem:
Water inlet screen blocked by debris.
Solution:
Drill four additional water inlet holes. This is recommended for commercial and high usage applications.
1
Mark hole locations in center of anti-ventilation plate lower radius, directly above inlet screen screws. Mark hole locations on both sides of gearcase, using a square template, as shown.
2
Center punch, then drill ⁵⁄₃₂ in. (4.0 mm) holes through radius (at 45° angle) into water passage, as shown.
Figure 1: marking water inlet holesFigure 2: drilling water inlet holes

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Water Pump Impeller Kit

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.