OMC Service Bulletin No. 2202 - High Speed Overheating

March 1988 OMC bulletin on control-valve tee hose routing and high speed overheating on 200 and 225 Loop Scavenged outboards with 3.0 Litre OMC Sea Drive.

OMC Outboard Service Bulletin
Powerhead
No. 2202
March, 1988
Subject:
High Speed Overheating
Models:
200 and 225 Loop Scavenged Outboards
3.0 Litre OMC Sea Drive®
Problem:
The preformed bend Ⓐ in the control valve to tee hose may have been pulled below the hose clamp Ⓑ causing the hose to kink at location Ⓒ. If this hose is restricted it will pressurize the thermostat diaphragms and cause high speed overheating.
Solution:
Loosen hose clamp Ⓑ and pull the hose up so the bend Ⓐ is above the clamp. Retighten clamp.
Control valve hose diagram, locations A B and C

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Water Pump Impeller Kit

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.