OMC Service Bulletin No. 2204: Loss of RPM at High Speed

Ignition troubleshooting for loop-scavenged OMC outboards equipped with 35 amp alternators.

OMC Outboard Service Bulletin
Ignition System
No. 2204
March, 1988
Subject:Loss of RPM at High Speed
Models:All Loop-Scavenged with 35 Amp Alternator
Symptoms:One or more of the following:
  • 500-800 RPM loss at FULL THROTTLE
  • Up to 500 RPM loss when trim is operated
  • Slow acceleration
Corrective Action:

Perform all ignition tests for the model you are working on. Pay particular attention to charge coil ohms resistance and voltage output tests.

Refer to Ignition Section, Indexing Flywheel, Erratic Ignition information in the current Service Manual.

If all components checked good, a partial breakdown of the charge coil(s) may still be possible. This condition, along with sustained high-speed operation and engine temperature, could result in low charge coil output and misfiring. Replace stator assembly.

Note On CU and earlier models: If misfiring occurs at FULL THROTTLE and RPM is near 6000 (maximum operating RPM), the electronic speed limiter may be controlling the RPM. Install a higher pitch propeller and retest.

CR88-35

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.