December 1989 troubleshooting bulletin for 40, 48 and 50 HP outboards, covering Touch-Trim, rough idle, and gearcase water intrusion.
OMC Outboard Service Bulletin
Shop Information

No. 2216
December, 1989

Subject:Service UpdateModels:1989 and Newer 40, 48 and 50
SYMPTOMPROBABLE CAUSEACTION
Touch-Trim™ model that will not raise or lower.- Trim cable out of adjustment

- Trim unit malfunction
Adjust the trim cable as described in Section 5 of the Service Manual.

Remove trim cable from trim unit and raise valve off seat by gently prying up on cable connector with a broad blade screwdriver. If unit extends or lowers, unit is okay, recheck trim cable adjustment. If unit does not extend replace trim unit.

⚠ The Touch-Trim unit must only be serviced as a complete assembly. No detail parts are available. To avoid personal injury, do not attempt to service or disassemble any part of the hydraulic unit. The internal components and fluid are under extreme pressure.

Excessive tilt effort on Touch-Trim™- Tilt tube nuts overtorqued

- Cable misadjusted

- Trim unit has lost its nitrogen charge
Torque tilt tube nuts as described in Section 5 of the Service Manual.

Adjust the trim cable as described in Section 5 of the Service Manual.

Remove trim unit from engine and open side valve by gently lifting by prying up with a broad blade screwdriver. If rod extends slowly and/or can be pushed back down, replace unit.

⚠ The Touch-Trim unit must only be serviced as a complete assembly. No detail parts are available. To avoid personal injury, do not attempt to service or disassemble any part of the hydraulic unit. The internal components and fluid are under extreme pressure.

Note The trim unit is designed to produce a specific effort at a specific rate of lift. If you increase the rate of lift the effort will also increase.

Printed in USACR89-30
SYMPTOMPROBABLE CAUSEACTION
Engine starts and runs but idles rough and/or pops out lean.- Linkage synchronization misadjusted

- Engine not warming up

- Needs carburetor mixture adjusted

- Debris in carburetors
Adjust linkage as described in Section 1 of the Service Manual.

Thermostat inoperative - remove thermostat and check for any debris on the seat. Clean and retest - if still inoperative replace thermostat.

With both the linkage adjustment and thermostat operation to specifications, perform the carburetor mixture adjustment as described in Section 2 of the Service Manual.

All systems check to specifications and the engine is unresponsive to carburetor mixture adjustment, disassemble carburetor for cleaning following the instructions outlined in the Service Manual.

During routine gearcase inspection water is detected in lubricant and gearcase will not pass a pressure and vacuum test.- Shift rod bushing loose or out of placeFlush gearcase and apply OMC Adhesive M to threads of the shift rod housing nut. Install nut and torque to 48-60 in. lbs. (5-7 N·m).
Printed in USACR89-30

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.