OMC Service Bulletin No. 2224: Driveshaft Pinion Shimming Procedure

April 1990 gearcase bulletin describing collar clearance and correction methods for OMC Universal Driveshaft Shimming Kit P/N 393185.

OMC Outboard Service Bulletin

Driveshaft Pinion Shimming Procedure

40 - CU, CC        55 - 1976 thru 1979
48 - CU, CC        60 - CS thru CO
50 - 1975 thru CC

Collar, P/N 328361, from OMC Universal Driveshaft Shimming Kit, P/N 393185, might not seat against driveshaft bearing housing when performing shimming procedure.

To obtain an accurate pinion shimming dimension when using OMC Universal Driveshaft Shimming Kit, the Collar from the kit must press against the driveshaft bearing housing when the pressing screw of the tool is properly tightened.

Because of a change to the driveshaft and the driveshaft bearing housing, the driveshaft could interfere with the collar before the collar can contact the bearing housing.

There are three possible corrections:

1
MODIFY your existing collar by following the diagram below.
2
SPACE your existing collar away from the driveshaft by placing thrust washer Ⓐ, P/N 330441 used on 20-30 models, between the bearing housing and collar.

PURCHASE a new collar, P/N 328361, from OMC SysteMatched Parts and Accessories. All new collars are chamfered for proper clearance.

Factory illustration 1Factory illustration 2

Related marine products

eBay: OMC / Evinrude part 328361

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.