OMC Service Bulletin No. 2226 - OMC Engine Tuner

OMC Engine Tuner and carbon deposit buildup in two-cycle engines.

OMC Outboard Service Bulletin
Fuel Systems
No. 2226
May, 1990
Subject:
OMC Engine Tuner
Models:
All
Problem:

We have noticed an increase in occurrence of carbon deposits accumulating on the pistons and combustion chamber of some engines. In small quantities these deposits are considered normal for any two cycle engine. Under normal circumstances seasonal treatment with OMC Engine Tuner as outlined in all Johnson and Evinrude Outboard and OMC Sea Drive service manuals will adequately control these deposits.

Poor quality fuel, use of non NMMA TCW II rated oil and unusual operating conditions, can greatly accelerate the formation of these deposits.

Solution:

Under these circumstances OMC Engine tuner should be applied once every 50 hours of operation.

If not periodically removed these carbon deposits can accumulate to the point of sticking the piston rings. This allows hot combustion gases to travel past the rings and down the sides of the piston. This can result in poor running quality and reduced engine performance. When combined with the extreme heat and pressure of full throttle operation, these gases can cause piston overheating, distortion and lubrication break-down which could lead to permanent engine damage.

The use of premium grade fuels is specifically encouraged. Most national brand premium fuels contain detergents and dispersant ingredients advertised to prevent intake valve and fuel injector deposits. These ingredients can extend engine life while maintaining a high level of performance.

CR90-27