OMC Service Bulletin No. 2228 - Engine Will Not Idle or Engine Spits Lean

Carburetor idle-channel cover gasket deformation on 1988 and newer V4 and V6 cross-flow models.

OMC Outboard Service Bulletin
Fuel System
No. 2228
July, 1990
Subject:
Engine Will Not Idle or Engine Spits Lean
Models:
V4 and V6 Cross Flow Models - 1988 and Newer
Problem:

Deformed carburetor cover gasket restricting idle channel in carburetor. Swelling might be caused by some fuels.

Solution:

Inspect entire fuel system for proper operation. If fuel system is satisfactory:

1Check the condition of the idle channel cover gasket on all carburetors. One or all might be deformed and restricting the carburetor idle channel. For ease of servicing, remove the top carburetor on V4 models and the center carburetor on V6 models.
2If any gasket is deformed, install new gaskets on all carburetors. Any new P/N 334353 gasket ordered from your OMC Parts Distributor will have no gasket material in the idle channel area.
3If a new gasket is not available, cut out the deformed portion of the gasket. Use care to not cut through the sealing portion of the gasket.

Assemble the carburetors and check the synchronization and linkage adjustments using the OMC Service Manual for the model being serviced.

Figure 1 - deformed gasketFigure 2 - gasket shapeFigure 3 - gasket modification
CR90-41

Related marine products

eBay: OMC / Evinrude part 334353

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.