OMC Service Bulletin No. 2247: Loose Propeller Shaft Housing Tab Screws

September 1991 OMC bulletin on loose propeller shaft bearing housing tab screws and washer 328743 for V6 outboards.

OMC Outboard Service Bulletin
Gearcase
No. 2247
September, 1991
Subject:
Loose Propeller Shaft Housing Tab Screws
Models:
All V6 Outboards With Tab Retainer Propeller Shaft Bearing Housings
Problem:
Loss of torque retention on propeller shaft bearing housing tab screws
Solution:
Figure 1: retaining tab screws and washers with OMC Ultra Lock

Install washer P/N 328743 under each tab retaining screw

1 When the above models are in for service, check the propeller shaft bearing housing screws for the presence of washers (A) between the screws (B) and retainer tabs. If no washers are present, remove the screws and add a washer P/N 328743 to each screw.

Apply OMC Ultra Lock and reinstall screws and washers so the washers are between the screw heads and the retainer tabs. Torque screws to 20-24 ft. lbs. (27-33 N·m).

Note Use OMC Ultra Lock even if the patch lock screw is new.

CR91-48

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Hub Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 328743

Search for original or compatible replacement part 328743

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.