No. 2251 Rev. 1 - Replacement Driveshaft Bearing Housing

This March 1992 revision explains installation of the replacement driveshaft bearing housing for 40 thru 50 recreational and commercial models.

OMC Outboard Service Bulletin
Gearcase
No. 2251 Rev. 1
March, 1992
Subject:
Replacement Driveshaft Bearing Housing
Models:
1989 and Newer, 40 thru 50 Recreational
1991 and Newer, 40 Commercial
Problem:

For 1992, the three retaining holes in driveshaft bearing housing assembly, P/N 435274, were increased to accept 5/16 in. screws. The original driveshaft bearing housing used on 1989 thru 1991 gearcases accepted 1/4 in. retaining screws. The new driveshaft bearing housing assembly, P/N 435274, is the service replacement for all models.

Solution:

When installing the new driveshaft bearing housing in a gearcase that is tapped for 1/4 in. screws, follow the procedure outlined in the service manual and install one washer Ⓐ, P/N 301250, with each original 1/4-20 screw. Tighten the screws to a torque of 96-120 in. lbs. (11-14 N·m).

Driveshaft bearing housing with three washers A at retaining screws

Related marine products

eBay: OMC / Evinrude part 435274

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.