OMC Service Bulletin No. 2257 - Erratic Initial Operation of T'N'T

Published in March 1992, this bulletin describes erratic initial trim and tilt operation on outboards equipped with a FasTrak midsection and the procedure for clearing air from the hydraulic pump.

OMC Outboard Service Bulletin
Midsection
No. 2257
March, 1992
Subject:
Erratic Initial Operation of T'N'T™
Models:
All With FasTrak™ Midsection
Problem:

When the trim unit is operated the first time, the trim motor runs, but the outboard motor does not tilt or it moves erratically.

Air that was above the fluid in the reservoir can work its way into the pump passages because the outboard motor is inverted during shipment. Air can remain in the pump inlet after the motor is turned upright. The oil pump cannot pump air, so the pump does not work.

Solution:

Open manual release valve Ⓐ.

Manually tilt the outboard motor up and down. Repeat, if necessary. Cycling the outboard motor up and down in the tilt range pushes fluid through passages and helps remove air.

Close the manual release valve and power operate the trim unit up and down through the complete trim and tilt ranges. Repeat until the outboard motor trims and tilts smoothly.

Factory figure showing manual release valve A on FasTrak midsection

Related products

Trim and tilt service supplies - recommendations coming soon.