April 1992 OMC bulletin announcing four service tools for outboard maintenance, including bearing installation, flushing and shift rod height measurement.

Service tools referenced: 338646, 339029, 389997, 435299, 508217, 912084, 987742.

OMC Outboard Service Bulletin
Service Tools
No. 2260
April, 1992
Subject:New Service Tools
Models:ALL

These four outboard service tools have been developed during the past year and are not included in the 1992 Outboard Essential Service Tool Kit, P/N 508217. These tools are available from OMC SystemMatched™ Parts and Accessories.

1 Wrist Pin Bearing Installer Ⓐ, P/N 338646, was developed to install full complement wrist pin bearings in 1992 90° loop models.

1 Replacement Tip Kit Ⓑ, P/N 987742, consists of two large and two small replacement tips for OMC Universal Spanner Wrench, P/N 912084.

2 Flush Tool, P/N 435299, was developed for fresh water flushing of the jet outboards. The tool features an on/off water flow valve and a quick-disconnect hose fitting.

3 A taller rod, P/N 339029, has been developed for OMC Universal Shift Rod Height Gauge Kit, P/N 389997. This gauge is required to set shift rod heights on 30 in. “Z” models. All new Universal Shift Rod Height Gauge kits will be shipped with the taller rod.

Figure 1 wrist pin installer and replacement tipsFigure 2 flush toolFigure 3 taller gauge rod
CR92-5

Related marine products

eBay: OMC / Evinrude part 508217

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.