June 1992 OMC bulletin addressing VRO oil tank hose and clamp combinations on specified V6 outboards.

OMC Outboard Service Bulletin
Accessories
No. 2261
June, 1992
Subject:VRO® Oil Tanks
Models:1992/93 60° V6 and 1993 90° Loop V
Problem:Late production 1992 and early production 1993 oil tanks have been assembled with one of the following combinations of oil supply hoses:
  • ¼″ ID vinyl hose with plastic ratchet clamp P/N 322654
  • ⁵⁄₁₆″ ID reinforced rubber hose with ratchet clamp P/N 322654
  • ⁵⁄₁₆″ ID reinforced rubber hose with stainless steel worm clamp P/N 123112

Certain combinations of oil hoses, engine inlet fittings, and clamps can allow air to leak into the oil supply system. Remember that air leaking into the supply system does not always mean oil is leaking out.

These air leaks could cause permanent powerhead damage or errant “no oil” warning horn signals.

Solution:If you notice errant “no oil” signals, oil leaks, or loose oil supply hoses, replace the oil hose between the primer bulb and engine inlet fitting. Lubricate both ends of the hose with outboard lubricant before installing on the primer bulb and inlet fittings.

Use ¼″ ID reinforced rubber hose and plastic ratchet clamps, P/N 322654 when you replace the supply hose.

¼″ ID reinforced rubber hose is available in 25 ft. rolls as P/N 333485.

CR92-33

Related marine products

eBay: OMC / Evinrude part 322654

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.