OMC Service Bulletin No. 2264 - Hard Shifting

Diagnostic checks and shift assist kit information for 1991 (EI) and early 1992 (EN) 60-degree V6 engines.

OMC Outboard Service Bulletin
Ignition
No. 2264
September, 1992
Subject:
Hard Shifting
Models:
All 1991 (EI) and Early 1992 (EN) 60° V6
Problem:
Shifting out of gear is difficult.
Solution:
Check the obvious first:
  • Engine shift lever at twelve-o-clock position in NEUTRAL
  • Remote control greased
  • Correct routing of control cables
  • Correct length control cables
  • Kinked control cables
  • Excessive free-play in control cables
  • Throttle plates are completely closed
  • 6° ATDC idle ignition timing
  • Consider installing OMC control cables

1Water test the boat and check the following:

  • 650 RPM engine idle speed in FORWARD
  • Engine is “still in” or “stuck in” QuikStart™. For test procedure, refer to Function Tests - Quik-Start in Service Manual.

2Check all items listed! If engine is still difficult to shift, install shift assist kit P/N 435696.

Factory illustration 1, tachometer at 650 rpmFactory illustration 2, shift assist kit components

Related marine products

eBay: OMC / Evinrude part 435696

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.