OMC Service Bulletin No. 2272: Erratic Tachometer Readings

OMC tachometer wiring correction for 1993 9.9 and 15 HP electric-start outboards.

OMC Outboard Service Bulletin
Electrical System
No. 2272
March, 1993
Subject:
Erratic Tachometer Readings
Models:
1993 (ET) 9.9/15 Electric Start
Problem:
Alternator stator will not support a normal tachometer installation.
Solution:
If an installation requires a tachometer, tachometer P/N 174985 must be used. Set the tachometer’s selection switch to position “5”.

Use circuit tee, P/N 585075, to connect the tachometer to the stator. Install circuit tee as follows:

  1. 1 Disconnect the gray lead from the stator yellow/gray circuit. Cap yellow/gray circuit with plug P/N 328074 Ⓐ.
  2. 2 Install circuit tee P/N 585075 Ⓑ in the yellow/blue circuit.
  3. 3 Connect gray lead Ⓒ to circuit tee Ⓑ.

Note If you install service replacement stator, P/N 585087, remove the circuit tee Ⓑ and move the gray lead Ⓒ back to the yellow/gray circuit.

Factory wiring diagram showing circuit tee B, gray lead C, and plug A

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Outboard Ignition Spark Tester

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 174985

Search for original or compatible replacement part 174985

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.