March 1996 OMC bulletin No. 2304 describes inspection and replacement of 1996 modular wiring system key switches with inadequate internal lubrication.

OMC Outboard Service Bulletin
Accessories
No. 2304
March, 1996

⚠ Safety Warning

Subject:
Key Switches
Models:
All 1996 (ED)
Problem:
The key switch could have inadequate internal lubrication. Without proper lubrication, the switch could stick in the START position and not return to the RUN position, or the switch might not turn the engine off when the emergency safety clip and lanyard is pulled off.
Solution:
All 1996 Modular Wiring System key switches must be inspected. The following descriptions identify a GOOD key switch:

1 A switch with silver-colored terminals A.

2 A switch with a white mark on the key insert B or a gray key insert.

2 A switch with a white mark C on its barrel.

3 A pre-wired surface mount remote control with a green or yellow mark D under its warm-up lever.

If one or more of the above descriptions applies to a key switch, the switch has proper lubrication and can be used.

4 Any key switch you inspect that has copper-colored terminals must be replaced. This switch could have inadequate lubrication. Send warranty claim and the key switch to OMC Warranty Department. Use the following information on the warranty claim:

• Flat Rate Code: IS-99
• Flat Rate Time: 0.8 Hour
• Failing Part: 9999912

⚠ DO NOT attempt to apply lubrication to the key switch. Doing so will not adequately lubricate the switch. Key switches that have copper-colored terminals must be replaced.

Factory illustration 1 for bulletin 2304Factory illustration 2 for bulletin 2304Factory illustration 3 for bulletin 2304Factory illustration 4 for bulletin 2304

Related products

Replacement key switches for 1996 OMC modular wiring systems - recommendations coming soon.