OMC Service Bulletin No. 2314 - Intermittent Communication

OMC identifies possible cold solder joints in the FICHT communication cable and explains its inspection and upgrade procedure.

Service tools referenced: 437955.

OMC Technical Service Bulletin
ROUTE TO:SERVICE MANAGERSERVICE WRITERTECHNICIAN 1TECHNICIAN 2TECHNICIAN 3FILE
Service Tools
No. 2314
May, 1997
Subject:
Intermittent Communication
Models:
All FICHT™ Equipped
Problem:

1Our continuing quality assurance testing has identified the possibility of cold solder joints in the DB9 (serial) connector Ⓐ of your FFI™ Communication Cable, P/N 437955.

If your cable has cold solder joints, it might cause intermittent or permanent interruptions in the OMC Diagnostic Software Program.

The OMC Diagnostic Software will alert you to a communication problem and it will interrupt your diagnostic session. Remember that there are other possible causes for a communication fault. Check the list of causes in your software user's guide.

Figure 1, communication cable and DB9 connector A
Solution:

Return your Communication Cable, P/N 437955, to Ace Industries at the address below. Ace Industries will inspect and upgrade your cable at no cost to you.

The upgraded cables will be identified by a red band near the DB9 (serial) connector.

Ace Industries
Attn: Dever Krueger
1000 McLaughlin Drive
Munford, TN 38058

Related products

Communication cable P/N 437955 - replacement availability may vary.

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Digital Multimeter, Marine Heat-Shrink Butt Connectors

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 437955

Search for original or compatible replacement part 437955

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.