OMC Service Bulletin No. 2329 - Shift Lever

Shift lever retaining screw inspection and Shift Lever Kit installation for 25/35 three-cylinder outboards.

OMC Technical Service Outboard Bulletin
Midsection
No. 2329
May, 1998
Subject:Shift Lever
Models:25/35 3-Cylinder, 1997 (EU) & Older

Problem: Some outboards have exhibited erratic shifting due to a loose retaining screw that secures the shift lever to the shaft. This could happen even when the screw originally had the correct torque.

Solution:

1 Check the above outboards when they are in your shop for routine service. Determine if the shift lever screw Ⓐ is loose.

2 If the screw has loosened, do not retighten the screw. Replace the shaft and screw with Shift Lever Kit, P/N 439560. This kit has a locknut and washer on a stud that will hold the shift lever securely to the shaft. Install kit following procedure outlined in your OMC Service Manual. Tighten locknut to 60-84 in. lbs. (7-9 N·m).

Factory illustration 1Factory illustration 2

Related marine products

eBay: OMC / Evinrude part 439560

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.