OMC Bulletin No. 2332 explains factory crankcase oil removal and initial break-in lubrication for four-stroke outboards.

OMC Technical Service Bulletin
ROUTE TO: □ SERVICE MANAGER  □ SERVICE WRITER  □ TECHNICIAN 1  □ TECHNICIAN 2  □ TECHNICIAN 3  □ FILE
Powerhead
No. 2332
June, 1998
Subject:
Break-In Lubricant
Models:
All 4-Stroke
Problem:
4-Stroke outboards are tested at the factory, then all crankcase oil is drained before shipping.

Note A 4-Stroke outboard will be seriously damaged if it is started without oil in the crankcase.

Solution:
Do not start any new 4-Stroke outboard until the crankcase oil level is checked and break-in lubricant added.

1 2 1. Before initial start-up, add OMC® Genuine Parts Four Stroke Outboard Break-In Lubricant. This lubricant is used for the first 20 hours of engine operation. Refer to engine Operator’s Manual for filling procedure and crankcase capacity.

3 2. After completing 20 hours of engine operation, install new oil filter and Evinrude/Johnson Ultra™ 4-Stroke Crankcase Oil.

Factory illustration 1 for bulletin 2332Factory illustration 2 for bulletin 2332Factory illustration 3 for bulletin 2332