November 1998 OMC bulletin identifying rotor holding and pin removal tools for RescuePro and FICHT outboards.

OMC Technical Service Outboard Bulletin
ROUTE TO: □ SERVICE MANAGER  □ SERVICE WRITER  □ TECHNICIAN 1  □ TECHNICIAN 2  □ TECHNICIAN 3  □ FILE
Service Tools

No. 2336
November, 1998

Subject:New Service ToolsModels:30/55/70 RescuePro™ and all FICHT® Systems

Two outboard service tools were developed during the past year and were not included in the 1998 Outboard Essential Service Tool Kit, P/N 507419. These tools are available from OMC® Genuine Parts.

1 Rotor Holding Tool, P/N 345104, retains rotor during propeller nut removal and installation for all RescuePro models. A gauge A is included to check for wear between the rotor and rotor housing.

2 Pin Removal Tool, P/N 345117, removes pin from engine harness throttle position sensor (TPS) connector on FFI™ models. This tool is also used on OMC Stern Drive (GM EFI) models.

Figure 1 rotor holding toolFigure 2 pin removal tool

CR98-49

Related marine products

eBay: OMC / Evinrude part 507419

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.