OMC Outboard Service Bulletin No. 2339 (November 1998) addresses pulse fittings for 25/35 3-Cyl., 65 Com., 1998 & 1999 (EC & EE), S/N 4508301 - 4555858.

Whenever one of the affected models is in your shop for routine service, check the crankcase pulse fitting I.D. with a 7/32 in. drill bit. If the drill goes through, replace the fitting with a new fitting, P/N 303492, that has a 3/16 in. inside diameter. Only the correct parts are being shipped from OMC. If you have this part in your inventory, check the fitting to verify that it has the correct 3/16 in. I.D.
1 2 25/35 3-Cyl. Remove fuel pump mounting screws A. Pull the fuel pumps and heat shield aside and remove the pulse fitting; recreational engines B, commercial engines C. Check the fitting I.D. Replace fitting if the I.D. is too large.
3 65 Com. Remove the pulse hose from the crankcase pulse fitting. Check the fitting I.D. Replace fitting if the I.D. is too large.
If the fitting I.D. is too large, remove the support spring from the pulse hose and inspect it. If the spring is damaged, contact OMC Technical Service as engine damage might have occurred.
Use OMC Pipe Sealant with Teflon on fitting threads. Hand start fitting and tighten to 60-84 in. lbs. (7-9 N·m). Replace pulse hose if it is damaged.



Listings matching the part number
Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.