2008-03(S): New Service Tools - 2008 Model Year

Factory service bulletin dated May 27, 2008, introducing tools for Evinrude E-TEC V6 L2 and M2 gearcases.

Evinrude Johnson service bulletin header
Date: May 27, 2008
MODELS: 2008 and Newer Evinrude E-TEC Outboards - V6 Gearcases
No. 2008-03(S)
SUBJECT: New Service Tools - 2008 Model Year

New service tools have been developed for 2008 Model Year outboards. The following tools are required for servicing the new “L2” and “M2” gearcase assemblies used on V6 model outboards. These tools will not be shipped automatically as part of the essential tool program and must be ordered as needed. Refer to the appropriate service manual for gearcase identification and service procedures.

354060 Puller, Propeller Shaft Bearing Housing: Used to remove propeller shaft bearing housing on “L2” and “M2” type gearcase assemblies with pressed in bearing housings.

Factory illustration of service tool
Factory illustration 006784

354059 Pressing Fixture: Used to support gearcase assembly on floor press for propeller shaft bearing housing installation.

Factory illustration of service tool
Factory illustration 006782

354057 Installer, Propeller Shaft Bearing Housing “M2” Gearcase: Used with Service Tool Handle P/N 345822, pressing fixture, P/N 354059, alignment screws, P/N 354140, and 10 ton floor press for pressing propeller shaft bearing housing into gearcase housing.

354058 Installer, Propeller Shaft Bearing Housing “L2” Gearcase: Used with service tool handle, P/N 345822, pressing fixture, P/N 354059, alignment screws, P/N 354140, and 10 ton floor press for pressing propeller shaft bearing housing into gearcase housing.

354140 Alignment Pins: Used to align propeller shaft bearing housing on “M2” gearcase. Install temporarily before pressing bearing housing into gearcase housing.

345822 Handle, Service Tool: Used with installer P/N 354057 or P/N 354058 for pressing propeller shaft bearing housing into gearcase housing. (This tool was originally offered in 1999. Many dealers may already own this tool.)

Factory illustration of service tool
1. Installer, “M2”
2. Installer, “L2”
3. Alignment pins
4. Handle

354056 Installer, Propeller Shaft Seals: Used to install inner and outer propeller shaft seals on “M2” type gearcase assemblies.

Factory illustration of service tool
Factory illustration 006824

354139 Installer, Propeller Shaft Rear Bearing: Used to install rear propeller shaft bearing on “M2” type gearcase assemblies and newer “O”, “L”, “M” and “L2” bearing housings with extended 0.065 in. for fish line trap feature.

Factory illustration of service tool
Factory illustration 006825

5007749 Gearcase Alignment Gauge (M2): Used with Gearcase Alignment Gauge Kit, P/N 5006349, to check the alignment of gearcase housing on V6 “M2” gearcases that have experienced impact damage and/or internal bearing and gear failure. (Available Fall 2008)

5007750 Gearcase Alignment Gauge (L2): Used with Gearcase Alignment Gauge Kit, P/N 5006349, to check the alignment of gearcase housing on V6 “L2” gearcases that have experienced impact damage and/or internal bearing and gear failure. (Available Fall 2008)

Factory illustration of service tool
Factory illustration 006822

Related tools and supplies

Click here to search on Amazon

Click here to search on eBay

As an Amazon Associate, EverythingOutboards earns from qualifying purchases. Affiliate links may earn a commission.