OMC Technical Service Bulletin No. 2364, March 2000. Motor Cover Latch. Models: 1999 (EE) and 2000 (SS) 8 4-Stroke.

OMC Technical Service Bulletin
Power Head

No. 2364
March, 2000

Subject: Motor Cover Latch Models: 1999(EE) and 2000(SS) 8 4-Stroke Problem: In some applications, the angle that the operator

pulls on the upper motor cover while tilting the outboard could cause the upper and lower motor covers to flex enough that the top cover slides for- ward and disengages the front retaining hook.

Solution: [1] Order the hardware listed below from your o OMC® Genuine Parts Distributor. Drill out the riv- ets originally installed to fasten the retaining hook on the front of the upper motor cover. Install the new stop behind the existing hook and retain with the two 10-24 in. screws and nylock nuts.

Required:

Stop, P/N 446511 (1) Screw, P/N 333430 (2) Nut, P/N 121470 (2)

OMC will cover labor and material only if the engine is under warranty. You can submit warranty using OMNI or a standard Warranty Allowance Re- quest. Use the following information.

DRC8093

- Group Code: C

- Failing Part: 446356 - Flat Rate Code: L

- Flat Rate Time: 0.5

CRO00-04

Factory illustration 1

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 446511

Search for original or compatible replacement part 446511

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.