OMC Service Bulletin No. 2377 - Inconsistent Idle and Hard Starting

August 2000 bulletin for 2000 (SS) 4 HP outboards concerning low-speed needle packing nut adjustment.

OMC Technical Service Bulletin
ROUTE TO: □ SERVICE MANAGER   □ SERVICE WRITER   □ TECHNICIAN 1   □ TECHNICIAN 2   □ TECHNICIAN 3   □ FILE
Fuel Systems

No. 2377
August, 2000

Subject:
Inconsistent Idle and Hard Starting
Models:
2000 (SS) 4 Hp
Problem:

A number of engines were shipped with a possible loose low-speed needle packing nut. This can cause an air leak into the low-speed circuit of the carburetor causing an inconsistent idle or hard starting.

Solution:

If you encounter an engine with these symptoms, proceed as follows:

  1. Remove the choke knob and the securing the stop button on the front panel of the lower motor cover. Remove the 4 screws securing the lower motor cover, and move it to allow access to the air silencer.
  2. Remove the 4 screws holding the air silencer cover, then remove cover and tighten the packing nut. The nut should be tight but still allow the low-speed needle to be rotated for adjustment with a screwdriver.
  3. Reinstall the air silencer cover with just the two lower screws. Set the throttle cam and roller pick-up point as shown in your OMC Service Manual.
  4. Start and warm up the engine in a test tank. Set idle speed as shown in service manual and adjust low-speed mixture needle for highest, consistent idle speed, then turn needle out (richen) a 1/8 turn.
  5. Stop engine, remove air silencer cover and check that packing nut is still tight.
  6. Assemble air silencer and lower motor cover.
Factory illustration

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Carburetor Cleaner Spray, Jet Cleaning Wires

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.