Johnson SB-1004 - Strengthened Driveshafts

Issued February 21, 1964, this bulletin documents the introduction of strengthened necked-down driveshafts on electric-shift Johnson outboards and identifies the earlier non-necked-down and newer shaft part numbers.

Johnson Motors Service Bulletin gray letterhead
February 21, 1964
SUBJECT:   Strengthened Driveshafts - Electric Shift Engines
MODELS:
RK - 40 HP (1962 and up)
V4A - 75 HP (1962 and up)
V4M - 90 HP (1964 and up)
Factory comparison of two driveshafts, indicating the necked down area and its exclusive use on electric shift engines

Improved, strengthened driveshafts are now being used in production on all electrical shift engines - 40, 75 and 90 HP.

Strengthening of these shafts was achieved by necking down an area of the shaft just below the crankshaft splines. The greater strength of this new shaft results from its ability to permit torsional twisting in event the propeller strikes an underwater object - similar to the action of torsion bars now being used on the suspension of some automobiles - and like its automotive counterpart it does not take a permanent set after twisting.

Dealers are requested to continue using non-necked down shafts for service on manual shift engines only. Use the necked down shafts for service on electric shift engines. See below.

Non-Necked Down Driveshafts

378802 - RD, RDS-24M thru
378803 - RDK, RDSL-24M thru
378622 - V4S-13
378623 - V4SL-13
378622 - V4A-13 only
378623 - V4AL-13 only
378622 - VX-10S thru (60 HP)
378623 - VXL-10S thru (60 HP)

Necked Down Driveshafts

379875 - RK-24M thru
379876 - RKL-24M thru
379882 - V4A-14
379883 - V4AL-14
379882 - V4M-10S
379883 - V4ML-10S

Sincerely,

JOHNSON MOTORS

Robert Compton

NOTE: Post on your RD, RK-40 HP, V4-75 HP and V4M-90 HP
      indexes under the heading "Lower Unit".