Johnson Service Bulletin SB-1013 - Improved Driveshaft Bearing Housing Sealing

March 28, 1964. Johnson described a revised upper gearcase seal for 1964 60, 75 and 90 HP engines, using an O-ring and a machined bearing-housing groove in place of the earlier gasket arrangement.

Johnson Motors Service Bulletin gray factory letterhead

March 28, 1964 SB-1013

SUBJECT:   IMPROVED SEALING - DRIVESHAFT BEARING HOUSING TO UPPER GEARCASE.

ON ENGINES:
60 HP ModelsVX(L)-10S75 HP ModelsV4S(L)-16A75 HP ModelsV4A(L)-16D90 HP ModelsV4M(L)-10S

All engines listed above are now being built with an O-ring (302688) between the driveshaft bearing housing (378621) and upper gearcase in place of Part #308413 Gasket. The addition of this O-ring has necessitated machining an O-ring groove in the driveshaft bearing housing.

When repairing a gearcase on any 1964 model listed above, use the gasket between the bearing housing and gearcase if the housing does not have an O-ring groove. Use the O-ring in this application if the bearing housing has an O-ring groove. See Fig. 1.

The same procedure applies when replacing the driveshaft bearing housing on any 1964 or pre-1964 V4 series engine, since the new service housing may or may not have an O-ring groove. Eventually all service stock of 378621 Bearing Housing will be of the type having the groove.

Please note that some of the first 1964 production engines built to this change were made using both an O-ring and gasket. In the event one of these engines is disassembled in your shop, use both O-ring and gasket during re-assembly.

Figure 1: Exploded view of upper gear housing, bearing housing 378621, gasket 308413 and O-ring 302688
Fig. 1
JOHNSON MOTORS
Robert Compton
Administrative Assistant

RC:eb

NOTE:  Post on VX-60 HP, V4-75 HP and VM 90 HP indexes under the heading "LOWER UNIT".

Historical parts reference

302688 - O-ring; 308413 - earlier gasket; 378621 - driveshaft bearing housing. The factory instructions distinguish housings with and without a machined O-ring groove. Early 1964 engines built during the transition may require both seals, as specified in the bulletin.

Browse 1960s Johnson service bulletins