Johnson Service Bulletin SB-1007 Rev. 1 - Propeller Hub Slip Torque

December 1966 revision identifying six propeller hub marking styles and the appropriate slip torque specifications. The two-page factory chart is preserved below as full-page images.

Johnson Motors gray Service Bulletin letterhead

December, 1966

SUBJECT: TORQUE VALUES - Bushing to Propeller Hub

As outlined in SB-#1007, dated February 26, 1964, and accompanying torque chart, several methods of identification were used to distinguish propellers having increased hub torque from those made to former specification.

The propellers now being produced again have plain hubs and in some cases, have increased torque values.

There are presently six different types of propellers in the field which are identified as follows:

Plain Hub (Produced Prior
to Identification Program)


Two Dots

Three Dots
Two Dots and "V" groove

Three Dots and stamped Let. "U"

Plain Hub (Produced since
termination of Identification
Program)

All new propellers (plain hub) and propellers with "Three Dots" should be checked against the specifications in the lower, right half of the enclosed chart.

JOHNSON MOTORS

Carl Klawonn
Administrative Assistant

CK:rs

NOTE: Post on your LD-5 HP through VM-100 HP Indexes under the heading "Lower Unit". Destroy SB-#1007, dated February 26, 1964.

Original Johnson factory propeller identification and slip torque chart, page 2
Original Johnson factory propeller identification and slip torque chart, page 3