Johnson Service Bulletin SB-1007 - Propeller Hub Torque Changes

Issued February 26, 1964, this bulletin announces increased propeller bushing slip-torque requirements for certain 28-90 HP applications, excluding 50 HP propellers. It describes five identification markings and refers to a separate factory specification sheet, which is not included in the supplied scan.

Johnson Motors Service Bulletin header
February 26, 1964
SUBJECT: CHANGE IN TORQUE VALUES - BUSHING TO PROPELLER HUB.
Changes have been made to increase the amount of torque required to cause the propeller bushing to slip in the propeller hub. These changes affect propellers that are used only on 28 HP thru 90 HP engines - with exception to the 50 HP propeller. The 50 HP prop and props that fit engines of 18 HP or less have not received an increase in hub torque.
Several methods of identification are used to distinguish propellers having increased hub torque from those made to former specifications. To determine what torque applies to any of these changed propellers, merely compare the identification markings on the gearcase side of the propeller bushing with one of the five photos shown on the enclosed specification sheet. After the propeller has been matched with one of these photos, the respective hub torque will be found in the column to the right of the photo.
Both standard and optional propeller sizes will be identified in this matter. The various types of identification markings used are:
Plain Hub
Two Dots
Three Dots
Two dots and "V" groove
Three Dots and stamped letter "U"
We suggest that you place the enclosed specification sheet on a wall near your propeller torque fixture for ready reference.
Sincerely,
JOHNSON MOTORS
Robert Compton Administrative Assistant
RC:eb
NOTE: Post on your MQ - 9½ HP through VM-90 HP indexes under the heading "Lower Unit". Destroy SB-881 dated 12/13/61.

Related bulletin

SB-1007 directs dealers to destroy SB-881 (December 13, 1961). The accompanying torque specification sheet is not present in the scanned document; numerical hub torque values are therefore not reproduced here.