Johnson Service Bulletin SB-1009 - Model Change

March 5, 1964. Johnson documented changes to the carburetor and throttle cam on 1964 40 HP RD, RDS and RK outboards, including non-interchangeable 26S and 26R service parts and revised synchronization marks.

Johnson Motors Service Bulletin gray letterhead

March 5, 1964

SUBJECT:   MODEL CHANGE

ON ENGINES:  1964 - 40 HP Models  RD (L)-26S to RD (L)-26R
                          RDS (L)-26S to RDS (L)-26R
                          RK (L)-26S to RK (L)-26R

A modified carburetor and a newly designed throttle cam are now being used in production on all - 40 HP models. Engines that are built using the modified carburetor and new cam are identified by a model change (26S to 26R). See complete model change listing above.

Because the contour of the new 26R model throttle cam has been changed (compare Figures 1 and 2), precautions must be taken when replacing a cam on a 1964 - 40 HP engine. The 26S model requires a 26S style carburetor and cam, and the 26R model requires a 26R style carburetor and cam. Do not use these parts interchangeably.

Several other service parts cannot be used interchangeably between the 26S and 26R model carburetors. Those parts used only on the 26S model are preceded by a dot (•) in the parts catalog; those used only on the 26R are preceded by a dagger (†). The following is a complete listing of these parts:

MODEL 26S

309246 Throttle Cam (RD, RDS & RK)
309935 Orifice #68 (RD, RDS & RK)
308956 Nozzle (RD, RDS & RK)
380060 Carb.Body (RD)
380064 Carb.Body (RDS, RK)
379573 Carburetor (RD)
379489 Carburetor (RDS, RK)

MODEL 26R

311023 Throttle Cam (RD, RDS & RK)
309415 Orifice #64 (RD, RDS & RK)
311024 Nozzle (RD, RDS & RK)
380061 Carb.body (RD)
380065 Carb.body (RDS, RK)
379879 Carburetor (RD)
379880 Carburetor (RDS, RK)
Figure 1: 311023 throttle cam for 26R with alignment arrow
Fig. 1
Figure 2: 309246 throttle cam for 26S with alignment arrow
Fig. 2

over

PAGE 2      SERVICE BULLETIN SB-#1009JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086

SYNCHRONIZING SPARK AND GAS ON 26R MODEL ENGINES.

Figure 1 illustrates that the new 26R model cam has two synchronizing alignment marks rather than a single mark as does the 26S cam.

Engines equipped with the 26S cam are adjusted so that the carburetor throttle valve starts to open the moment a cam synchronizing mark is in precise alignment with the angular intake manifold boss. (See position of alignment arrow, Fig. 2). Engines equipped with the 26R model cam, however, are adjusted so that the throttle valve starts to open the moment the angular intake manifold boss is precisely between the two cam synchronizing marks (see position of alignment arrow, Fig. 1).

JOHNSON MOTORS

Robert Compton
Administrative Assistant

RC:eb

NOTE: Post on your RD, RK - 40 HP index under the heading "Carburetor".

Historical parts reference

The 26S and 26R carburetors, throttle cams, nozzles, orifices and carburetor bodies are model-specific. The factory cautions against interchanging these parts. Refer to the original comparison above when identifying replacement components.