Johnson Service Bulletin SB-1015A - 9½ HP Engine Performance

Issued February 1965, this supplemental bulletin addresses rough idle, flat spots, and related performance concerns on Johnson 9½ HP MQ engines, with additional carburetor inspection and adjustment procedures following SB-1015.

Johnson Motors Service Bulletin letterhead

February, 1965 SB-#1015A

SUBJECT:   PERFORMANCE OF 9½ HORSEPOWER MOTORS:
            ROUGH IDLE, FLAT SPOTS, ETC.

ON ENGINES:   9½ H.P., MQ (L)

The majority of field complaints concerning rough idling, flat spots, etc., on 9½ H.P. MQ models, have, for the most part, been remedied since our issuance of SB-#1015 concerning service information on 9½ H.P. Models MQ (L) - 10S.

Unfortunately, however, there still remain some isolated cases where a customer is dissatisfied with the performance of his 9½ H.P., MQ engine - even after the procedure outlined in SB-#1015 has been C O R R E C T L Y carried out. If this should be the case, and the engine does not perform as it should, it is recommended that the following additional checks and/or modifications be made:

A.

Remove the core plug (item 39) P/N 550078, covering the high speed nozzle opening. Check the size of the opening with a #36 drill (.1065"). If the drill will not pass through the opening, enlarge the nozzle opening with the #36 drill to .1065". When replacing the core plug, be sure to seal it with an appropriate sealer.

B.

Check the size of the idle restrictor port with a #60 drill (.040").

The restrictor port is located in the small pie-shaped opening beneath the carburetor barrel in the float chamber (see figure 1). Be sure that the restrictor port is open to the cross-drilled hole immediately below it. If the #60 drill will not fit in the restrictor port opening or if the port is not open to the cross-drilled hole immediately below it, enlarge the port, along its full length, to .040", using the #60 drill.

C.

Remove the slow speed needle valve (item 55), the slow speed needle valve packing nut (item 54), packing and washers (item 52 and 53). Coat the large core plug (item 42) on the side of the carburetor body with a thin film of oil. Pressurize the cavity behind this core plug with a slight amount of air pressure by applying air pressure through the slow speed needle valve opening. If bubbles appear in the oil, this core plug should be removed and a new one installed, using an appropriate sealer around the edges of the new core plug.

PAGE 2 SERVICE BULLETIN   SB-#1015A
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086
Factory photograph of carburetor idle restrictor port with pin-vise and number 60 drill
Fig. 1
D.

Check carburetor/magneto synchronization.   (Refer to SB-#1015, page 3).

E.

Certain climatic conditions or types of fuel may result in the engine running slightly on the lean side during acceleration. If this is the case, remove the high speed orifice plug (item 75) and enlarge the opening in it to .052 inches, using a #55 drill. The standard opening is .048".

NOTE

All item numbers cited above can be found on page 5 of your 1964, 9½ H.P. MQ parts catalog.

NOTE: Post on your 9½ H.P. MQ index, under "Miscellaneous".

JOHNSON MOTORS

N. Peter Hansen
Administrative Assistant

NPH:rs