Johnson Service Bulletin SB-1025 Rev. 1 (November 1964)

This factory revision addresses fuel starvation on certain 3 HP JW and JH engines. Johnson identified improperly formed leaf-plate back-up strips as an additional cause and advised checking their height before changing the carburetor orifice plug.

Johnson Motors Service Bulletin factory letterhead

November, 1964.

SUBJECT:FIELD COMPLAINT:  3 HP ENGINES STARVING FOR GAS AND NOT DEVELOPING THE SPECIFIED MINIMUM RPM AT FULL THROTTLE WITH A TEST WHEEL.
APPLIES TO:

JW Models prior to serial nos:  JW-20B #128060
JWL-20B #103115

JH Models prior to serial nos:  JH-20B #117487
JHL-20B #5000

A quick check with the original service bulletin #SB-1025 will show that we have formerly recommended the use of a #30 orifice plug in place of a #28 orifice when the subject problem was encountered.

Additional investigation has shown, however, that the cause of this problem is not entirely due to the use of a leaner jet, but that it also results from improperly formed back-up strips (service part #203173) on the leaf plate assembly.

Because of this we are asking you to first check and see that the leaf back-up strips are formed properly. If, after tank testing, it is determined that a lean condition still exists, causing the subject complaint, install a larger orifice plug #29 (service part #310758) presently being used on production and available from your parts distributor.

Factory diagram of leaf plate and back-up strips, showing one-quarter-inch measurement

To check the leaf back-up strips simply remove the carburetor and leaf plate assembly so that the distance between the top of the back-up strip and the machined surface of the base can be measured as indicated. This dimension is ¼" on properly formed back-up strips, but we suspect you will find many that will measure less than the ¼" specified dimension.

If the back-up strip is found to be too low, the leaf cannot lift sufficiently to provide ample fuel for full-throttle running. The corrective measure in this instance is back-up strip replacement. DO NOT ATTEMPT TO REFORM BACK-UP STRIPS THAT ARE TOO LOW. Use new strips from your stock of service parts. We have checked and determined that this problem has occurred during assembly and want to assure you that all service stock of #203173 back-up strips will be found to be formed properly.

JOHNSON MOTORS

Jack Penland
Service Promotion Manager

JP/ll

NOTE: Post on JW, JH - 3 HP index under "CARBURETOR".

Factory parts and references

203173 - Leaf-plate back-up strip; specified clearance ¼ inch.

310758 - No. 29 carburetor orifice plug, recommended only if a lean condition remains after checking the strips.

SB-1025 - Original bulletin referenced by this revision.

Historical factory service information reproduced for research and restoration. Verify applicability and safe procedures before working on an engine.