Johnson Service Bulletin SB-1025 - 1964 3 HP Fuel Starvation

Issued August 24, 1964, this bulletin describes a high-speed carburetor orifice change for 1964 Johnson 3 HP engines experiencing fuel starvation and reduced full-throttle speed.

Johnson Motors Service Bulletin factory letterhead

August 24, 1964

SUBJECT:FIELD COMPLAINT:  1964 - 3HP ENGINES STARVING FOR GAS AND NOT DEVELOPING THE SPECIFIED MINIMUM RPM AT FULL THROTTLE WITH A TEST WHEEL.
APPLIES TO MODELS:
JW (L) - 19A
JH (L) - 19A

Your factory service department has received a number of complaints on 1964 - 3HP engines, indicating that occasionally an engine is found which will not run properly at high speeds unless the choke is pulled out slightly. These same engines also fail to develop the specified minimum rpm with a test wheel. Both situations would indicate that the engine is starving for gas.

We are now recommending that the #28 orifice plug (fixed high-speed jet) be replaced with a #30 orifice (service part #309345) whenever these conditions are noted on a 1964 - 3HP engine. Use of this larger diameter orifice plug will remedy the starving and low top-rpm problems.

Order #309345 orifice plug from your parts distributor. It is the same one that was used on the 1963 - 3HP engine. Use service tool #379664 FIXED JET SCREWDRIVER when removing and installing carburetor orifice plugs.

Sincerely,

JOHNSON MOTORS

Robert Compton
Administrative Assistant

RC/lfl

NOTE:  Post on JW, JH - 3HP index under heading "CARBURETOR".