Johnson Service Bulletin SB-1026 - Hard Starting, 90 HP

Issued August 26, 1964. Factory instructions for adjusting the choke solenoid on 90 HP V4M(L)-10S through 10R engines when insufficient choke-valve closing causes hard starting.

Johnson Motors Service Bulletin factory letterhead

August 26, 1964

SUBJECT: HARD STARTING - 90 HP - MODELS V4M(L)-10S THRU 10R.

The subject problem may be the result of insufficient choke valve closing while the engine is being cranked with the electric starter. Closing of the chokes during starting is controlled primarily by the choke solenoid.

Problems of this nature can be remedied by moving the choke solenoid outward to cause a greater degree of choke valve closing. The original solenoid setting of 1/2 inch (measured between the carburetor flange (A) and the end of the solenoid (B), Fig. 1) can be increased up to 11/16 inch maximum. Adjustment is achieved by loosening the front solenoid retaining screw three to four turns and moving the solenoid.

Several adjustments may have to be attempted before an adjustment is reached that is correct for the particular engine. On some engines, the maximum setting of 11/16 inch may cause flooding.

Figure 1: choke solenoid with carburetor flange A and solenoid end B measurement points
Figure 1

Sincerely,

JOHNSON MOTORS

Robert Compton
Administrative Assistant

RC/ll

NOTE: Post on VM-90 HP index under "CARBURETOR".

Historical service reference

The factory specifies a 1/2-inch original choke-solenoid setting, adjustable up to 11/16 inch maximum. The bulletin warns that the maximum setting may cause flooding on some engines. See Figure 1 for the original measurement points.