Johnson Service Bulletin SB-1032 - Shifter Dog Failures

Issued October 1, 1964, this Johnson factory bulletin addresses improperly formed shifter yokes in 60 and 75 HP manual-shift engines. It documents the inspection clearance and adjustment required to reduce premature shifter dog wear.

Johnson Motors Service Bulletin letterhead

October 1, 1964

Subject: SHIFTER DOG FAILURES - 60 & 75 HP MANUAL SHIFT ENGINES.

We have just discovered that a number of 60 & 75 HP manual shift engines were built with improperly fashioned shifter yokes (part 307098), and we feel that this situation can contribute to premature shifter dog wear.

It will be necessary to partially disassemble the gearcase and remove the two shifter yokes to check for this condition. Once the shifter yokes are removed from the gearcase, assemble only the two yokes using part 306860 screw and part 553078 nut as shown in Figure 1. If the yokes have been formed properly, a maximum of 1/8" clearance will exist as indicated. If the yokes are improperly formed, upwards of 1/4" will be measurable as shown in Figure 2.

Figure 1: properly formed shifter yokes with 1/8 inch maximum clearance, screw 306860 and nut 553078
Fig. 1 (properly formed shifter yokes)
Figure 2: improperly formed shifter yokes showing quarter-inch gap and bend locations
Fig. 2 (improperly formed shifter yokes)

Shifter yokes that are improperly formed can be re-shaped for further use simply by bending each yoke at the location shown in Fig. 2, until end gap is reduced to 1/8 inch maximum clearance.

- over -

PAGE 2SERVICE BULLETIN #1032
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086

We are also requesting that shifter yokes be removed and checked on all 1964 and 1965 model 60 & 75 HP engines that you have in stock before turning the engines over to the customer. Do the same to any service gearcases you have recently received as a further preventative measure against shifter-dog failure.

JOHNSON MOTORS Robert Compton Administrative Assistant

RC/ll

NOTE: Post on VX-60 and V4-75 HP indexes under "LOWER UNIT".

Factory references

Bulletin SB-1032, October 1, 1964. Relevant parts: 307098 shifter yoke, 306860 screw, and 553078 nut. Original factory illustrations are preserved on page 1.