
SB-1035
NOVEMBER 13, 1964
SUBJECT: IMPORTANT CARBURETOR INFORMATION - 90 HP
REFER TO THIS BULLETIN BEFORE ORDERING REPLACEMENT PARTS FOR A
90 HP CARBURETOR.
You will find that two different style carburetors are used on 90 HP
motors.
One type has only one gasket between the float bowl and carburetor body
and will be found only on 1964 models (see Fig. 1). Replacement parts
for this carburetor must be ordered from the 1964 - 90 HP Parts Catalog.
The other type has two gaskets and an aluminum plate between the float
bowl and body (see Fig. 2). This type will be found on all 1965 models
and occasionally on a 1964 model because it was used by the service de-
partment as a warranty replacement late in the 1964 model year. Replace-
ment parts for this carburetor must be ordered from the 1965 - 90 HP
Parts Catalog.


Figure 1
Figure 2
A few of the critical internal parts which cannot be used interchangeably
between these two carburetors are listed here - to emphasize the impor-
tance of correct replacement-part ordering: float bowl, carburetor body,
high-speed tube assembly, high-speed jet, slow-speed needle valve and float
bowl gaskets.
Please note also that the following procedure is recommended to align the
two gaskets and the aluminum plate mentioned in paragraph no. three (3)
whenever the gaskets and aluminum plate have been removed.
PAGE 2 SERVICE BULLETIN SB-1035
JOHNSON MOTORS, DIVISION OF OUTBOARD MARINE CORPORATION, WAUKEGAN, ILLINOIS 60086


Figure 3
Figure 4
Step (1): Position gaskets and aluminum plate over machined surface of
carburetor body.
Step (2): Install all float bowl attaching screws into body to align
gaskets and plate as shown in Fig. 3.
Step (3): Install all four high-speed-tube assemblies to carburetor
body, leaving tube assembly retaining screws finger tight.
Step (4): Proceed to tighten high-speed-tube assembly retaining screws
securely, starting with the inner most screws and working out-
ward toward each end.
This procedure may seem time consuming at first; however, it is the only
method which will assure perfect alignment of fuel passages in the car-
buretor body with corresponding holes in the gaskets and aluminum plate.
It also evens the gasket out so that it will rest properly to prevent
fuel or air leaks and prevents the gasket from becoming shredded by the
screw threads during assembly - a condition which could result in ob-
structed fuel passages.
After the four high-speed-tube assemblies have been secured, remove the
float bowl retaining screws and proceed to assemble the float bowl to the
body. Again, start all bowl retaining screws finger tight, then work
outward towards each end of the bowl when drawing the screws up securely.
JOHNSON MOTORS
Jack Penland
Service Promotion Manager
NOTE: Post on VM-90 HP index under "CARBURETOR".