Johnson Service Bulletin SB-1174 - Ignition Failure and Faulty Vacuum Switch

Issued October 1968, this bulletin explains how a marginal vacuum switch can interrupt ignition on Johnson V4T(L)-14 100 HP outboards and recommends checking the switch before replacing the pulse pack or other ignition components.

Johnson Motors Service Bulletin factory letterhead

October, 1968

SUBJECT:IGNITION FAILURE AND FAULTY VACUUM SWITCH
ON MODEL:V4T(L)-14, 100 H.P.

As you know, the purpose of the Vacuum Switch on the 1968 100 horse-power is to delay the electrical current to the voltage suppressor and subsequently to the Pulse Pack until the engine has made a few revolutions. At this time, the Vacuum Switch makes contact and completes the ignition circuit, allowing the engine to be started.

A marginal Vacuum Switch will usually function properly for starting the engine and sometimes even for normal running. However, marginal switches may cause needless replacement of ignition components, such as the Pulse Pack, when missing and/or total ignition failure are experienced.

For example, when idling the engine to pick up a skier, the throttle is quickly opened to get under way and the engine stops. At this point the crankcase vacuum drops off, allowing the marginal switch to open contact thus opening the ignition circuit. Although the engine can again be started, we have good reason to believe many are blaming other ignition components and making needless, costly replacements. Oddly enough, replacing the Pulse Pack has been known to cover up a malfunctioning Vacuum Switch.

Before making such a needless replacement, we strongly urge you to bypass the Vacuum Switch with a jumper wire and make sure the Vacuum Switch is not the cause of failure.

JOHNSON MOTORS Carl Klawonn Administrative Assistant

CK:rm

NOTE: Post on your VM - 100 Index under the heading "Ignition".

Historical service reference

Vacuum switch and pulse pack ignition diagnosis: Johnson V4T(L)-14 100 HP, 1968. SB-1174 documents a vacuum-switch fault that can mimic pulse pack failure and cause intermittent or total loss of ignition.