Johnson Service Bulletin SB-1184 - Oversize Pistons & Rings

Issued March 1969 for the GT-10S, this bulletin introduced .020-inch oversize pistons and ring sets and specified separate installation clearances for the upper and lower rings. It superseded the parts listed in SB-1162.

Johnson Motors Service Bulletin factory letterhead

March, 1969

SUBJECT:OVERSIZE PISTONS & RINGS
ON MODEL:GT-10S

Should re-boring of GT cylinders be necessary, we have available for shipment a new .020" oversize piston and ring set. These parts supersede those listed in Service Bulletin #1162, dated April, 1968. The part numbers and prices are as follows:

PART NO.DESCRIPTIONQTY. PER
ENGINE
NET PRICE
EACH
383893Piston, .020" oversize4$4.00
383894Piston ring set, .020" oversize4.65

The two piston rings supplied are different from each other. The piston ring with the square cross-section should be fitted to the lower ring groove. This ring should be fitted to provide .007" - .017" end gap when installed. The upper piston ring is a pressure back type and has a beveled edge. This beveled edge must be installed facing up. This ring should be fitted to provide .015" - .025" end gap.

The above parts should be ordered directly from Johnson Motors, Service Department, Waukegan, Illinois 60085.

JOHNSON MOTORS

Doug Cankar

Administrative Assistant

DC:rkm

Related service information

SB-1162 - Oversize Pistons & Piston Rings (April 1968): Earlier GT-series oversize piston and ring information, superseded by the parts listed in SB-1184.